Page 1 of 1
Cannot choose properties in post processor
Posted: Tue Sep 10, 2024 1:37 pm
by haishui
Hi STKO team.
- 5.png (464.16 KiB) Viewed 2835 times
When I was looking at the component stresses in the post-processing interface, I noticed that I couldn't select and display the related properties separately, which was not an issue before. What is the cause and how can I fix this?
Looking forward to hearing from you.
Re: Cannot choose properties in post processor
Posted: Wed Sep 11, 2024 10:39 am
by kesavapraba
Hi, This is strange! It doesn't happen generally. It is challending to suggest anything with limited details. Have you loaded and kept the mpco database in a default settings?
Re: Cannot choose properties in post processor
Posted: Sat Sep 14, 2024 1:59 am
by haishui
kesavapraba wrote: ↑Wed Sep 11, 2024 10:39 am
Hi, This is strange! It doesn't happen generally. It is challending to suggest anything with limited details. Have you loaded and kept the mpco database in a default settings?
Sorry, I don't get you. I haven't changed the settings of the MPCO database file.
Could you please tell me about how to check the settings of the mpco database?
Thanks a lot!
Re: Cannot choose properties in post processor
Posted: Mon Sep 16, 2024 9:04 am
by kesavapraba
I meant keeping the mpco, mpco.cdata, and other supporting files in the same folder.
Re: Cannot choose properties in post processor
Posted: Mon Sep 16, 2024 1:25 pm
by STKO Team
This happens when you don't have the mpco.cdata files next to the mpco files. Those are support files STKO uses to write extra information not available in OpenSees