How can i calibrate the concentrate plastic hinge from experimental data?
Posted: Wed Feb 08, 2023 1:00 pm
Dear STKO Team：
i am trying to build a plane model ,it's about a three story and two bay steel frame;
but the beam section is not same along the entire beam,a damage link is insert into the beam end,and its section is somewhat like RBS,its section is reduced a lot,and there is a gap between web and upper and lower flange(this damage link is design for sepecial purpose,to fracture firstly in flange then extend to web);
if i want to incorporate Modified IMK or some other suitabale model into my zerolength element
,how can i get the parameters like elastic rotational stiffness,My from experimental data(test of monotonic and cyclic test on connection with this damage link.)
could i get some recommendation or reference?
thanks a lot:-)
i am trying to build a plane model ,it's about a three story and two bay steel frame;
- 图片2.png (73.29 KiB) Viewed 1514 times
- 图片6.png (132.06 KiB) Viewed 1514 times
- 图片3.png (13.19 KiB) Viewed 1514 times
- 图片4.png (27.26 KiB) Viewed 1514 times
- 图片5.png (20.62 KiB) Viewed 1514 times
thanks a lot:-)