Analysis did not converge

[jpereirasan]

Dear STKO Team.

I am modeling a centrifugal test, basically it is a sandbox to which a dynamic analysis is performed. To simplify the modeling, it can be worked as a slope and apply the constraints correctly.

I have the problem that the model does not converge and i can not advance to the post process part, i think it has to do with an error in the analyze command, how can i fix it so that the model gives me at least a preliminary result?

I would be very grateful for your help.

[kesavapraba]

Hi, It seems you are dealing with 2D analysis since you have applied the boundary conditions in 2D. So, redo (or rotate the model) everything on X-Y plane instead of the current X-Z. Because, all the 2D modeling should be done in X-Y plane in STKO.

[jpereirasan]

Problem solved, thank you!

[STKO Team]

You're welcome