Hi,
I have built this model but it gives me error saing "invalid number of nodes or element type". Actually I am not able to chatch where is the problem in the model.
I attached the model.
Thanks in advance
Regards
Antonella
Element error
-
AntoMarinelli
- Posts: 47
- Joined: Thu Aug 05, 2021 8:53 am
Element error
- Attachments
-
- 60.rar
- (925.37 KiB) Downloaded 5 times
-
ValentinaSB
- Posts: 55
- Joined: Thu Dec 09, 2021 10:53 am
Re: Element error
Hi Antonella,
You got that error due to unstructured mesh and the use of the quad element. You need to use mesh controls and set up the structured mesh.
Anyway, now you have a convergence problem.
Try to check your parameters. For me, the tensile fracture energy of concrete looks too high.
Try to look also the post-processor and see what is happening there.
Let us know if you have any trouble.
Best,
Valentina
You got that error due to unstructured mesh and the use of the quad element. You need to use mesh controls and set up the structured mesh.
- Screenshot 2023-03-27 163334.jpg (276.05 KiB) Viewed 121 times
Try to check your parameters. For me, the tensile fracture energy of concrete looks too high.
Try to look also the post-processor and see what is happening there.
Let us know if you have any trouble.
Best,
Valentina
-
AntoMarinelli
- Posts: 47
- Joined: Thu Aug 05, 2021 8:53 am
Re: Element error
Thank you,
but the fracture energy is too high because it is a Fiber Rinforced Concrete so I can't low it.
but the fracture energy is too high because it is a Fiber Rinforced Concrete so I can't low it.
-
ValentinaSB
- Posts: 55
- Joined: Thu Dec 09, 2021 10:53 am
Re: Element error
Ok, so it can be reasonable, then just try to see in the post-processor what is happening.
Best,
Valentina
Best,
Valentina