Seven-story structure (convergence problem)

Post Reply
luckypants
Posts: 58
Joined: Wed Jun 17, 2020 6:07 pm

Seven-story structure (convergence problem)

Post by luckypants » Sat Oct 24, 2020 2:47 pm

Dear STKO Team:

I tried to build the seven-story structure with plastic hinges. However, there was the convergence problem in my model.
I couldn't get the result.

I also built the same model in ETABS to check the result. I found the ground motion caused structural damage and permanent displacement to the structure.

The following is my model. How could I solve the problem?

Any advice and helps that you provide are highly appreciated.

Best Regards
Attachments
sevenstory nonlinear.rar
(371.57 KiB) Downloaded 47 times
ETABS.jpg
ETABS.jpg (79.24 KiB) Viewed 906 times

Post Reply