error in compiling input file (mesh)

Post Reply
Telec
Posts: 25
Joined: Sun Oct 11, 2020 8:27 am

error in compiling input file (mesh)

Post by Telec » Tue Oct 20, 2020 11:06 am

hi,
I'm trying to model a simple beam with shellMIT4 element and elasticSectionMembrane. When I run the analysis I get this error:
stko2.PNG
stko2.PNG (56.38 KiB) Viewed 51 times
I think that depends by the mesh but I don't know how to fix it. I've used structured-quad-linear mesh. thx
Attachments
model.rar
(73.91 KiB) Downloaded 6 times

STKO Team
Posts: 325
Joined: Tue Oct 29, 2019 8:45 am

Re: error in compiling input file (mesh)

Post by STKO Team » Tue Oct 20, 2020 1:48 pm

It says that you assigned the ShellMITC element property (4 nodes) to some edges (2 nodes).

do this:
- select all using the full geometry selection (not sub-selection)
- drag the ShellMITC4 onto the graphic windows, if you keep the CTRL button hold, you will see that the command will be the Unassign From instead of the Assign To.
- drop (now the shellMITC4 should be assigned to nothing)
- select the full geometry again, and drag-and-drop the ShellMITC4 property

Probably what you did, was to un-check the Full Geometry selection button, thus moving to sub-selection. In that scenario, if you select everything, you will assign the Shell property also to edges, not only to faces.

Here is the fixed file:
model.zip
(95.28 KiB) Downloaded 3 times

Post Reply