Page 1 of 1

Convergence error

Posted: Thu Jul 30, 2020 12:45 pm
by o.arslan
Dear STKO team,

I would like to ask you If you could help me with the error that I attached here.

I have modeled my wall as a component element. There is a convergence error; however, I couldn't figure out the reason.

Best regards,

Onur Arslan

Re: Convergence error

Posted: Thu Jul 30, 2020 1:35 pm
by HannahCartwright
Hi Onur,

Based on the error, it seems that you included a displacement control as an integrator by choosing a target displacement of 0.2 units, however, you did not insert a load. To correct the problem, you must add a load as a condition first, before running the analysis.

I have attached a screenshot where you can see the specific error code.

I hope this helps!

Re: Convergence error

Posted: Thu Jul 30, 2020 4:23 pm
by o.arslan
Hello HannahCartwright,

Thank you for your help.

I fixed the problem and it run after that.

Best regards,

Onur Arslan