Convergence error

Post Reply
o.arslan
Posts: 2
Joined: Thu Jul 30, 2020 12:42 pm

Convergence error

Post by o.arslan » Thu Jul 30, 2020 12:45 pm

Dear STKO team,

I would like to ask you If you could help me with the error that I attached here.

I have modeled my wall as a component element. There is a convergence error; however, I couldn't figure out the reason.

Best regards,

Onur Arslan
Attachments
stko_CS_CL.PNG
stko_CS_CL.PNG (97.97 KiB) Viewed 229 times

HannahCartwright
Posts: 2
Joined: Fri Jul 17, 2020 1:12 pm

Re: Convergence error

Post by HannahCartwright » Thu Jul 30, 2020 1:35 pm

Hi Onur,

Based on the error, it seems that you included a displacement control as an integrator by choosing a target displacement of 0.2 units, however, you did not insert a load. To correct the problem, you must add a load as a condition first, before running the analysis.

I have attached a screenshot where you can see the specific error code.

I hope this helps!
Attachments
image (3).png
image (3).png (97.44 KiB) Viewed 226 times

o.arslan
Posts: 2
Joined: Thu Jul 30, 2020 12:42 pm

Re: Convergence error

Post by o.arslan » Thu Jul 30, 2020 4:23 pm

Hello HannahCartwright,

Thank you for your help.

I fixed the problem and it run after that.

Best regards,

Onur Arslan

Post Reply