Some features are missing

Post Reply
Asad005
Posts: 17
Joined: Sat Dec 07, 2019 6:50 am
Location: Italy

Some features are missing

Post by Asad005 » Sat Dec 07, 2019 11:37 pm

1. An issue in the Fiber section. No new window gets opened after clicking on the fiber for drawing the custom fiber section rather using the option of “Rectangular Fiber section”.
2. Option “RectangularFiber Section” is not available here as was available in the webinar session.
Screenshots from webinar along with screenshots of my STKO window are attached.
Attachments
Fiber section1.png
Fiber section1.png (767.78 KiB) Viewed 585 times
Fiber section.png
Fiber section.png (100.68 KiB) Viewed 585 times
Fiber section,1.png
Fiber section,1.png (675.99 KiB) Viewed 585 times
Fiber section,.png
Fiber section,.png (110.99 KiB) Viewed 585 times

MassimoPetracca
Posts: 37
Joined: Wed Jul 24, 2019 11:10 am

Re: Some features are missing

Post by MassimoPetracca » Sat Dec 07, 2019 11:50 pm

As for the material test window, also this feature is available in the first official release. In the Beta version you only have the custom fiber section.

There you should first click with the left-mouse-button in the first cell on the right ("Value" column of "Fiber section" attribute), then on the right-most part of the cell, a button with "..." (3 dots) will appear. Click it to open the fiber section builder window.

Asad005
Posts: 17
Joined: Sat Dec 07, 2019 6:50 am
Location: Italy

Re: Some features are missing

Post by Asad005 » Sun Dec 08, 2019 8:59 am

Thanks :)

Post Reply