Extraction of results at element end

Hello! In this section we'll talk about the post processing module and the data visualization.
Post Reply
Zeeshanbhat
Posts: 145
Joined: Wed May 27, 2020 3:48 pm

Extraction of results at element end

Post by Zeeshanbhat » Tue Oct 05, 2021 7:54 am

Dear Team,

How to extract the results from gauss points at end of a particular element intersecting at a node. Like In the given figure, . When I select the gauss point only gauss point of element 228 is selected. There are four elements joining at this node. So how can I select the gauss point of any other element at that particular node.
Any Suggestions will be highly appreciated.

Regards,
Zeeshan Bhat
Attachments
InkedCapturessa_LI.jpg
InkedCapturessa_LI.jpg (1.01 MiB) Viewed 376 times

STKO Team
Posts: 1346
Joined: Tue Oct 29, 2019 8:45 am

Re: Extraction of results at element end

Post by STKO Team » Tue Oct 05, 2021 8:04 am

Probably you can select only the gauss point with the largest value, because (by default) the gauss plot scales the size of the gauss particles according to their value.

Try to change the particle scale factor to Constant (on the bottom of the Editor of the Gauss plot).
Then try to select it again. A window should pop-up with all the overlapping gauss points

Post Reply