asdeasoft.net

Dear STKO team, Thank you for the advice, it actual worked for the nodal load on xx. However, when I try to apply a transversal load (on yy) I can't get a curve at all. I would also like to try a distributed load to represent better the acceleration from the seismic action, but doesn't work either. ...

Dear STKO Team,

I want to do a pushover analysis in this model in annex, but when I run it, the analysis is not smooth and also some errors appear on the exe. window (also in annex).
Do you know what can be wrong?

Many thanks!
S

Thank you very much!
It runs now

Dear STKO team,

I tried to run a push over analysis in the model below and it says it doesn't converge.
Previously I did a dynamic one and it was fine so I would like to ask for some help to understand what can be wrong with the pushover analysis.

Thank you in advance.
S

I'll, thank you very much!

Sure!

Thank you for warning me, Yes I made a mistake on my sw calculations excel.

However, I can't still run the model, the analysis fails.

Hello dear STKO team,

I applied your suggestion to my model but unfortunately didn't solve the problem, I continue to not be able to run the analysis.

Is there anything else I should do?

Best,
S

Hello! I've been making a STKO model following one of the e-learning videos and so far everything seems to be fine, except for one error that I can't figure out what's happening. When I run it, the following window appears (attached) I have tried changing the tolerance values and the same error appe...

When the software was working, after you guys help me last time, the file I have used to run perfectly. Now, with the same exact file, the program gives erros, and on the post processor, I don't have the beam extrusion functionality.