asdeasoft.net

Dear STKO Team,

I have a question about the calibration of the constitutive model of DamageTC3D. I have read the following paper "Micro-scale continuous and discrete numerical models for nonlinear analysis of masonry shear walls" in which this constitutive material model was described. I run a ...

Dear STKO team,

After I run the analysis properly which I didn't receive any error or convergence problem during the analysis, I had the error attached when I used the post-processor. I would like to ask you If you could help me with how to solve this problem.

Thank you in advance.

Dear STKO team,

I would like to use OpenSeesMP-STKO via DesignSafe-CI for my model. However, I received the error below. Is it because of the material which is not included version? Could you also inform us about DesignSafe STKO in terms of limitations?

Thank you in advance.

WARNING could not ...

Dear STKO Team,

Thank you so much for your support.

Sorry, I forgot to attach the error that I received. I also used -fullGenLapack as eigen solver in the analysis.

Best regards,

Dear STKO Teams,

Thank you so much for your help.

I have corrected the parts that you mentioned (removing the nodal load for time history and adding damping etc). However, I couldn't perform the modal analysis with the script that you posted on the forum ( https://asdeasoft.net/forum/viewtopic.php ...

Dear STKO Team,

I have created my model. However, in the TCL file it is shown that there are some nodes without element property. I used planar surface for the shell element. I have added some extra nodes on the planar surface in order to assign zero length elements. Also, I have another error ...

Dear STKO Team,

Thank you so much.

I like the monitor a lot. It is very nice to see. Do we need to create selection sets in order to monitor the forces? (I have two different selection sets in my file)

Dear STKO Team,

Thank you so much for your prompt reply.

Indeed the problem was the wipeanalysis option which was checked. However, I switch-off it and it ran :)

I would like to ask you a question about the cyclic option in the analysis command.

I used the same parameters (the one from the ...

Dear STKO Team,

I have added the TCL file of cyclic loading from your tutorials as a custom command. However, I received the error attached. I would like to ask you If you could help me.

Thank you in advance.

Best regards,